Open Drift

Open Drift is our most unrestricted class, allowing a wide range of vehicle builds and modifications. This class is built for all drivers looking to have some fun and push performance with fewer limitations while still meeting BCDA safety standards.

Open Drift Class Rules & Regulations

Community Responsibility

As a Drift Community operating under Bold Connections Drift Alliance Inc., we share the responsibility of protecting the future of drifting at our local facilities. Track access is a privilege — and one that is becoming increasingly rare. Do your part.

  1. Dirt drops are strictly prohibited. Cones, barriers, and tire walls are not to be used as clipping points. A strict one-warning policy is enforced. After that, you will be asked to leave the premises.
  2. Clean up after yourself. Used tires, zip ties, oil containers, bumpers, and any debris must be removed. Oil spills must be cleaned immediately. Leave the facility better than you found it.
  3. Cold zones are strictly enforced. Any unsafe behavior in a cold zone will result in immediate removal from the facility.
  4. Safety apparel is mandatory. All participants must wear closed-toe shoes, pants, and a t-shirt at minimum. Drivers are responsible for their passengers. Passengers must meet the same helmet and clothing requirements.
  5. End-of-day cleanup is mandatory. A cleanup crew will be organized at the end of every drift day. Please lend a hand — we are all in this together.

Conduct Policy

Poor behavior will not be tolerated. Enforcement is at the discretion of the Event Organizer(s) and/or Facility Owners. You may be asked to leave the facility and may be required to complete a full volunteer day at a BCDA event before returning, depending on the severity of the incident.

Basic Vehicle Requirements

All vehicles must meet the following standards:

  • Vehicle must be free of fluid leaks.
  • Electrical wiring must be professionally secured and organized. Improper wiring will not pass inspection.
  • All wheel studs and lug nuts must be present.
  • Battery must be securely mounted with the positive terminal covered.
  • Relocated batteries must include:
  1. Minimum 150 amp fuse breaker
  2. On/off kill switch within driver’s reach or properly mounted externally under windshield
  3. Windshield must be free of vision-impairing cracks.
  4. Turbo setups near brake masters must include adequate heat shielding.
  5. Minimum 5 lb fire extinguisher (metal mount, securely mounted within driver’s reach). Fire sticks are accepted.
  6. Working brake lights and headlights required.
  7. Adequate seat belts required. Improperly mounted harnesses will be rejected.
  8. Steering wheel and seats must be securely mounted.
  9. Harness bars are not accepted unless properly installed and welded to the main hoop and floor structure.

Helmet & Safety Requirements

  • Snell SA2020 or newer helmets required
  • Helmets must be in good condition and free of cracks
  • ECE helmets are no longer accepted
  • DOT-only helmets are not accepted (no exceptions)
  • All drivers and passengers must wear pants, t-shirt, and closed-toe shoes at minimum

Drivers are responsible for their passengers at all times.

Cage & Structural Rules

For full cage requirements, refer to:

  • BCDA Competition Tech Requirements

OR

Convertibles

Convertible vehicles must have:

  • Main hoop
  • Harness bar
  • Diagonal support
  • Rear stays

An OEM latching hardtop is acceptable, but must be factory OEM.

Tandem Policy

If you do not wish to tandem, notify the start line official or signal by activating your hazard lights. We are all here to learn and have a good time — respect each other’s comfort level.

Waiver Requirement

All drivers must sign a waiver prior to participating.

The waiver can be found in the event description where tickets are purchased.